Since everything in the circuit is in series .. .
-- The total resistance is (3 + 2) = 5 ohms.
-- The voltage across the 3-ohm resistor is 3/5 of the total voltage.
-- The voltage across the 2-ohm resistor is 2/5 of the total voltage.
(2/5) of (9 volts) = 18/5 = 3.6 volts .
Not knowing how to convert the type of measurement according to your way of learning from where ever you come from.
Assuming that the students
worldwide are being considered, because of the extremely large population, this
can be considered as a binomial distribution. A normal distribution is used most
usually as a fair approximation of the binomial. The mean is the expectation,
therefore:<span>
E[x] = np = (16)(0.22) = 3.52
<span>μ = 3.52 </span></span>
Answer:
Having the inside dimensions (ID) and the outside dimensions (OD) will allow you to figure out the wall thickness on tubing. You would need to subtract the ID from the OD and then divide by two. This number is the wall thickness.
Explanation:
Iron...................... hope this helpes
