Answer:
1. The final velocity of the truck is 15 m/s
2. The distance travelled by the truck is 37.5 m
Explanation:
1. Determination of the final velocity
Initial velocity (u) = 0 m/s
Acceleration (a) = 3 m/s²
Time (t) = 5 s
Final velocity (v) =?
The final velocity of the truck can be obtained as follow:
v = u + at
v = 0 + (3 × 5)
v = 0 + 15
v = 15 m/s
Therefore, the final velocity of the truck is 15 m/s
2. Determination of the distance travelled
Initial velocity (u) = 0 m/s
Acceleration (a) = 3 m/s²
Time (t) = 5 s
Distance (s) =?
The distance travelled by the truck can be obtained as follow:
s = ut + ½at²
s = (0 × 5) + (½ × 3 × 5²)
s = 0 + (½ × 3 × 25)
s = 0 + 37.5
s = 37.5 m
Therefore, the distance travelled by the truck is 37.5 m
Answer:
It can be concluded that the star is moving away from the observer.
Explanation:
Spectral lines will be shifted to the blue part of the spectrum if the source of the observed light is moving toward the observer, or to the red part of the spectrum when is moving away from the observer (that is known as the Doppler effect).
The wavelength at rest for this case is 434 nm and 410 nm (, )
Since, (444nm) is greater than (434 nm) and (420nm) is greater than (410 nm), it can be concluded that the star is moving away from the observer
<span>A cinder cone is formed from relatively low viscosity magma with a high gas content. Cinder cones
are formed by the volcanic ash, cinders that are formed around the volcanic
vent. Cinder cones have a bowl shaped crater and the shape of the cinder cones
depend on the ejected particles that formed the cinder.</span>
Answer:
d. epicentral distance scale
Explanation:
The depth of focus from the epicenter, called as Focal Depth, is an important parameter in determining the damaging potential of an earthquake. Most of the damaging earthquakes have shallow focus with focal depths less than about 70km. Distance from epicenter to any point of interest is called epicentral distance
<h3><u>Answer;</u></h3>
40 light bulbs
<h3><u>Explanation</u>;</h3>
The total resistance of components or bulbs in series is given as the sum of resistance of all the components.
Thus; if there are bulbs in series each with a resistance of 1.5 Ω, the the total resistance will be; 1.5nΩ
From the ohms law;
V = IR , where V is the voltage, I is the current and R is the resistor.
Thus; R = V/i
R = 120/2
= 60 Ω
But, there are n bulbs each with 1.5 Ω; thus there are;
n = 60/1.5
<u> = 40 Bulbs </u>