Ask question

Ask question

All categories

3 years ago

14

A linear network has a current input 7.5 cos(10t + 30°) A and a voltage output 120 cos(10t + 75°) V. Determine the associated im

pedance.

1 answer:

Leona [35]3 years ago

8 0

Answer:

16∠45° Ω

Explanation:

Applying,

Z = V/I................... Equation 1

Where Z = Impedance, V = Voltage output, I = current input.

Given: V = 120cos(10t+75°), = 120∠75°, I = 7.5cos(10t+30) = 7.5∠30°

Substitute these values into equation 1

Z = 120cos(10t+75°)/7.5cos(10t+30)

Z = 120∠75°/ 7.5∠30°

Z = 16∠(75°-30)

Z = 16∠45° Ω

Hence the impedance of the linear network is 16∠45° Ω

You might be interested in

What is light intensity?

soldi70 [24.7K]

Light intensity is the "amount of light given off a light source." Also, is the measure the wavelength of the amount of light given off by a light source.

Hope this helps.

7 0

2 years ago

Read 2 more answers

An automobile tire is inflated with air originally at 10.0°C and normal atmospheric pressure. During the process, the air is com

solong [7]

Answer:

(a) $3.81\times 10^5\ Pa$

(b) $4.19\times 1065\ Pa$

Explanation:

<u>Given:</u>

$T_1$ = The first temperature of air inside the tire = $10^\circ C =(273+10)\ K =283\ K$

$T_2$ = The second temperature of air inside the tire = $46^\circ C =(273+46)\ K= 319\ K$

$T_3$ = The third temperature of air inside the tire = $85^\circ C =(273+85)\ K=358 \ K$

$V_1$ = The first volume of air inside the tire

$V_2$ = The second volume of air inside the tire = $30\% V_1 = 0.3V_1$

$V_3$ = The third volume of air inside the tire = $2\%V_2+V_2= 102\%V_2=1.02V_2$

$P_1$ = The first pressure of air inside the tire = $1.01325\times 10^5\ Pa$

<u>Assume:</u>

$P_2$ = The second pressure of air inside the tire

$P_3$ = The third pressure of air inside the tire
n = number of moles of air

Since the amount pof air inside the tire remains the same, this means the number of moles of air in the tire will remain constant.

Using ideal gas equation, we have

$PV = nRT\\\Rightarrow \dfrac{PV}{T}=nR = constant\,\,\,(\because n,\ R\ are\ constants)$

Part (a):

Using the above equation for this part of compression in the air, we have

$\therefore \dfrac{P_1V_1}{T_1}=\dfrac{P_2V_2}{T_2}\\\Rightarrow P_2 = \dfrac{V_1}{V_2}\times \dfrac{T_2}{T_1}\times P_1\\\Rightarrow P_2 = \dfrac{V_1}{0.3V_1}\times \dfrac{319}{283}\times 1.01325\times 10^5\\\Rightarrow P_2 =3.81\times 10^5\ Pa$

Hence, the pressure in the tire after the compression is $3.81\times 10^5\ Pa$ .

Part (b):

Again using the equation for this part for the air, we have

$\therefore \dfrac{P_2V_2}{T_2}=\dfrac{P_3V_3}{T_3}\\\Rightarrow P_3 = \dfrac{V_2}{V_3}\times \dfrac{T_3}{T_2}\times P_2\\\Rightarrow P_3 = \dfrac{V_2}{1.02V_2}\times \dfrac{358}{319}\times 3.81\times 10^5\\\Rightarrow P_3 =4.19\times 10^5\ Pa$

Hence, the pressure in the tire after the car i driven at high speed is $4.19\times 10^5\ Pa$ .

8 0

2 years ago

The graph shows the range of frequencies commonly heard by some animals.

Vsevolod [243]

Concept:

Frequency- It is defined as the number of oscillations occur in one second.

Its SI unit is Hertz (Hz)

Given: Produced sound vibrations is 18,500 cycles in 0.75 seconds

∵ In 0.75 second, produced sound has oscillations = 18,500 cycles

∴ In 1.0 second, produced sound has oscillations = (18,500 ÷ 0.75) Hz

The frequency of the sound will be ≈ 24,667 Hz

From the study of the given graph, only the animals (c) Cats, (b) Moths and (a) Bats can hear the produced sound because their upper audible frequency range is greater than 24,667 Hz.

3 0

2 years ago

Read 2 more answers

The study and analysis of light according to its component wavelengths is called

BARSIC [14]

ANSWER:

The study and analysis of light according to its component wavelengths is called spectroscopy.

EXPLANATION:

Spectroscopy is the branch of science that is concerned with the investigation and measurement of spectrum produced when matter interacts with or emits electromagnetic radiation.It helps us to identify atoms and molecules in the object.Spectroscopy is used to find out Dopplers effect (the red shift and blue shift),which tells how fast the object is comming towards earth or moving away from the earth.

4 0

2 years ago

Which of the following is the best reason for using a scanning electron microscope?

torisob [31]

Answer is C: Ability to see three-dimensional images of the surfaces of object

Explanation:

To enable the technician see fractures and broken particles in a better resolution as the SEM sees the peaks and valley of the structure.

8 0

2 years ago