The phase change in which the water molecules become most orderly is the freezing. This is the process of changing water as liquid to its solidified form. The process of freezing is an exothermic which means that for this to occur, heat should be removed from the system.
The answer is to test a piece of untreated and treated under same conditions!
Any change in which the composition of material does not change that is it retains its identity but changes its state or form is known as a physical change.
The properties of metal to draw them into wires is known as ductility. When a copper is drawn into wire the only change that occurs is change in its shape and size no change will take place into its composition that is the wires are still possessing the properties of copper metal. Thus, a physical change takes place when copper is drawn into wire.
Answer:
2.038 seconds.
Explanation:
So, in the question above we are given the following parameters in order to solve this question. We are given a rate constant of 0.500 s^-, initial concentration= 0.860 M and final concentration= 0.310 M,the time,t =??.
Assuming that the equation for the first order of reaction is given below,that is;
A ---------------------------------> products.
Recall the formula below;
B= B° e^-kt.
Therefore, e^-kt = B/B°.
-kt = ln B/B°.
kt= ln B°/B.
Where B° and B are the amount of the initial concentration and the amount of the concentration remaining, k is the rate constant and t = time taken for the concentration to decrease.
So, we have; time taken,t = ln( 0.860/.310)/0.500.
==> ln 2.77/0.500.
==> time taken,t =2.038 seconds.
Answer: 34.4 g
Explanation:
As is in excess, is the limiting reagent and thus it will limit the formation of products.
According to stoichiometry:
2 moles of hydrogen produce = 1 mole of
2.5 moles of hydrogen produce = of
Mass of
But as % yield is 86%, mass of produded is
Thus 34.4 g of is produced.