Answer:
a. alkyne
b. alkane
c. alkyne
d. alkene
Explanation:
The general formula for each class of compound is given below
Alkane:
Alkene:
Alkyne: (assuming single multiple bonds)
Now let us classify according to the above formulas:
a. It has two hydrogen atoms less than the two times of carbon atoms hence, it's alkyne
b. It has two hydrogen atoms more than the two times of carbon atoms hence, it's alkane
c. It has two hydrogen atoms less than the two times of carbon atoms hence, it's alkyne
d. It has hydrogen atoms two times of carbon atoms hence, it's alkene
Answer:
C
Explanation
On the reactants side there is 4 Hydrogen atoms in total and two oxygen atoms on the left however on the right there is two hydrogen atoms and one oxygen atom. Leaving this equation unbalanced
In evaporation due to internal heat, kinetic energy of molecules increases and they come to the top and take out that heat with them when they evaporate thus causes cooling
in boiling as heat is given to the molecules so their kinetic energy increases and they start vibrating with great energy and thus causes heating
Answer:
As long as it is a blank solution of the reagent, the Absorbance will be 0 regardless of the path length.
Explanation:
Absorbance of light by a reagent of concentration c, is given as
A = εcl
A = Absorbance
ε = molar absorptivity
c = concentration of reagent.
l = length of light path or length of the solution the light passes through.
So, if all.other factors are held constant, If a sample for spectrophotometric analysis is placed in a 10-cm cell, the absorbance will be 10 times greater than the absorbance in a 1-cm cell.
But the reagent blank solution is called a blank solution because it lacks the given reagent. A blank solution does not contain detectable amounts of the reagent under consideration. That is, the concentration of reagent in the blank solution is 0.
Hence, the Absorbance is subsequently 0. And increasing or decreasing the path length of light will not change anything. As long as it is a blank solution of the reagent, the Absorbance will be 0 regardless of the path length.
Hope this Helps!!!
A "3" should but put in front of
<span>"cas o 4 "</span>