Does it is a complete qwestion? It
is not clearef
Answer:
Their melting and boiling points of alkanes are relatively low. The higher the molecular weight (the greater the number of carbons), the higher the boiling point.
I believe this question has the following five choices to
choose from:
>an SN2 reaction has occurred with inversion of
configuration
>racemization followed by an S N 2 attack
>an SN1 reaction has taken over resulting in inversion
of configuration
>an SN1 reaction has occurred due to carbocation
formation
>an SN1 reaction followed by an S N 2 “backside”
attack
The correct answer is:
an SN1 reaction has occurred due to carbocation formation
Answer:
Adding salt to the water increases the density of the solution because the salt increases the mass without changing the volume very much. When you add table salt (sodium chloride, NaCl) to water, the salt dissolves into ions, Na+ and Cl-. The volume increases by a small factor, but the mass increases by a bigger factor.
Explanation:
The product of the complete combustion of any fuel (in this case, acetylene) are indeed water and carbon dioxide.
Balancing the combustion reaction,
C2H2 +(5/2) O2 --> 2CO2 + H2O
The number of moles of C2H2 will be,
(12 g) x (1 mole/26 g) = 6/13 mole
Then, the number of moles of O2 is,
(12 g) x (1 mole/32 g) = 3/8 mole
Therefore the limiting reaction is the O2. Getting the amount of CO2 and H2O produced from balancing,
CO2 = (3/8 moles) x (2 moles CO2/ 5/2 mole O2)(44 g/ 1 mole) = 52.8 g
H2O = (3/8 moles) x (1 mole / 5/2 mole O2)(18 g / 1 mole) = 2.7 g
