Hello there!
Essentially, a control variable is what is kept the same throughout the experiment, and it is not of primary concern in the experimental outcome. Any change in a control variable in an experiment would invalidate the correlation of dependent variables (DV) to the independent variable (IV), thus skewing the results.
Answer:
true
Explanation:
The statement being made is completely true. This layer of rock is called a Sedimentary Rock level and is slowly formed over millions of years with minerals and organic remains from the bottom of the Oceans that may no longer be covered in water anymore. Since it is made up of all these minerals and remains, it is studied widely by Geologists and Archeologists to better understand the Earth's past.
Answer:
The number of turns in the solenoid is 230.
Explanation:
Given that,
Rate of change of current,
Induced emf,
Current, I = 1.5 A
Magnetic flux,
The induced emf through the solenoid is given by :
or
........(1)
The self inductance of the solenoid is given by :
.........(2)
From equation (1) and (2) we get :
N is the number of turns in the solenoid
N = 229.28 turns
or
N = 230 turns
So, the number of turns in the solenoid is 230. Hence, this is the required solution.
Answer:
a = 0.7267
, acceleration is positive therefore the speed is increasing
Explanation:
The definition of acceleration is
a = dv / dt
they give us the function of speed
v = - (t-1) sin (t² / 2)
a = - sin (t²/2) - (t-1) cos (t²/2) 2t / 2
a = - sin (t²/2) - t (t-1) cos (t²/2)
the acceleration for t = 4 s
a = - sin (4²/2) - 4 (4-1) cos (4²/2)
a = -sin 8 - 12 cos 8
remember that the angles are in radians
a = 0.7267
the problem does not indicate the units, but to be correct they must be m/s²
We see that the acceleration is positive therefore the speed is increasing