<span>1. The two qualities used to describe winds are direction and speed.
2. a local wind that blows during the day from an ocean toward land is a(n) sea breeze.
3. The increase in cooling that wind can cause is called the wind-chill factor.
4. Temperature differences between the equator and poles produce convection currents.
A movement that is parallel to Earth's Surface is called wind and a local wind is that wind that blows over a short distance.</span>
Answer:
Disposing of the discarded chemicals can be done by certain sfae methods mention as follows:
Explanation:
Most of the chemical wastes are dispose through the EHS waste program. Organic chemicals and solvents that can not be drain should be closed in a tight fitted container that has label on it as Hazardous waste, including strong acid and corrosive liquids.
Recycling of these chemicals and incineration is also use for the industrial chemical waste under professional guidance. Incineration is the process of burning chemicals in to ash through high thermal burning.
Endothermic reactions, on the other hand, absorb heat and/or light from their surroundings. For example, decomposition reactions are usually endothermic. In endothermic reactions, the products have more enthalpy than the reactants. Thus, an endothermic reaction is said to have a positive<span> enthalpy of reaction. This means that the energy required to break the bonds in the reactants is more than the energy released when new bonds form in the products; in other words, the reaction requires energy to proceed</span>
Answer:
24.7 amu
Explanation:
An isotope is when an element can have different number of neutrons but they have same number of protons.
In order to calculate the average atomic mass with the given information do the following operations:
First change de percentages to fractional numbers, divide by 100.
I like to make a table, to organize all data and I believe is easier to understand.
65/100 = 0.65
35/100 = 0.35
% fraction
65.0 0.65
35.0 0.35
total100.0 1
Now multiply each mass with their corresponding fraction
24 (0.65) = 15.6
26 (0.35) = 9.1
% fraction uma uma
65.0 0.65 24 15.6
35.0 0.35 26 9.1
total100.0 1 24.7
Finally you add the resulting mass and the units will be in uma.
15.6+9.1 = 24.7
Therefore the average atomic mass of this element will be 24.7 uma.
Check the table in the document attached
Answer:
pH = 4.17
Explanation:
According to the molar concentration you stated, pH of the solution is: 4.17
Remember that pH = - log [H⁺]
and [H⁺] = 10^-pH
When:
pH > 7 → Basic solution
pH = 7 → Neutral solution
pH < 7 → Acid solution
