condensation polymerization, since a byproduct of the reaction is a single molecule of water (hence condensation of water)
addition polymerization is if you add the two polymers together like blocks and should have no byproducts
esterification is when you combine an organic acid with an alcohol. Since neither of the two polymers look like acids, you can rule this out.
never heard of saponification, Im an mechanical engineer not an organic chemist
Answer:
Explanation:
Hello!
In this case, since the molarity of a solution is defined in terms of the moles of the solute and the volume of solution, given that the concentration of Cu(NH₃)₄²⁺ is 0.041 M, and there is only one copper atom per Cu(NH₃)₄²⁺ ion, we can compute the concentration of Cu²⁺ as shown below:
Best regards!
Answer:
3.81 g Pb
Explanation:
When a lead acid car battery is recharged, the following half-reactions take place:
Cathode: PbSO₄(s) + H⁺ (aq) + 2e⁻ → Pb(s) + HSO₄⁻(aq)
Anode: PbSO₄(s) + 2 H₂O(l) → PbO₂(s) + HSO₄⁻(aq) + 3H⁺ (aq) + 2e⁻
We can establish the following relations:
- 1 A = 1 c/s
- 1 mole of Pb(s) is deposited when 2 moles of e⁻ circulate.
- The molar mass of Pb is 207.2 g/mol
- 1 mol of e⁻ has a charge of 96468 c (Faraday's constant)
Suppose a current of 96.0A is fed into a car battery for 37.0 seconds. The mass of lead deposited is:
Answer:
11
Explanation:
the atomic number is the same as the number of electrons
4C₃H₅(NO₃)₃ ------> 12CO₂ + 6N₂ + 10H₂O + O₂
mol of CO₂ =
=
mol ratio of CO₂ : C₃H₅(NO₃)₃
12 : 4
∴ if mole of CO₂ = 0.568 mol
then " " C₃H₅(NO₃)₃ =
= 0.189 mol
∴ mass of nitroglycerin = mole * Mr
= 0.189 mol * 227.0995 g / mol
= 43.00 g