Answer:
52 mm/s (approximately)
Explanation:
Given:
Initial speed of the projectile is,
Angle of projection is,
Time taken to land on the hill is,
In a projectile motion, there is acceleration only in the vertical direction which is equal to acceleration due to gravity acting vertically downward. There is no acceleration in the horizontal direction.
So, the velocity in the horizontal direction always remains the same.
The horizontal component of initial velocity is given as:
Now, the velocity in the vertical direction goes on decreasing and becomes 0 at the highest point of the trajectory. So, at the highest point, only horizontal component acts.
Therefore, the projectile's velocity at the highest point of its trajectory is equal to the horizontal component of initial velocity and thus is equal to 52 mm/s.
Answer:
The value of the angle theta = 135degree, which is option c.
Explanation :
These are the options given in the question
a) 45 degrees
b)120 degrees
c)135 degrees
d)150 degrees
e) it is impossible to deliver a negative power.
The concept of work done on an object is applied here.
work = Fd
F = ma
work = mad
Work is a form of energy transferred by an object after the application of a force that act on the object. A step by step explanation is as attached below.
Answer:
36 Ω
Explanation:
Since the 3 resistors are connected in parallel.
The combined resistance of the resistor is
1/Rc = 1/R + 1/R + 1/R ...................... Equation 1
Where Rc = combined resistance of the three resistor, R1 = Resistance of each of the resistor
Rc = R/3 ....................... Equation 2
The formula of power is given as
P = V²/Rc
Rc = V²/P ................ Equation 3
Where V = Voltage, R = Combined Resistance, P = power.
Given: V = 48 V, 192 W.
Substitute into equation 3
Rc = 48²/192
Rc = 12 Ω
From equation 2
Rc = R/3
R = 3Rc
Where Rc = 12 Ω
R = 3×12
R = 36 Ω
Hence the resistance on each resistor = 36 Ω
Answer:
using sand
Explanation:
We can increase friction by making rough surface.