Answer:
a) Limiting: sulfur. Excess: aluminium.
b) 1.56g Al₂S₃.
c) 0.72g Al
Explanation:
Hello,
In this case, the initial mass of both aluminium and sulfur are missing, therefore, one could assume they are 1.00 g for each one. Thus, by considering the undergoing chemical reaction turns out:
a) Thus, considering the assumed mass (which could be changed based on the one you are given), the limiting reagent is identified as shown below:
Thereby, since there 1.00g of aluminium will consume 0.0554 mol of sulfur but there are just 0.0156 mol available, the limiting reagent is sulfur and the excess reagent is aluminium.
b) By stoichiometry, the produced grams of aluminium sulfide are:
c) The leftover is computed as follows:
NOTE: Remember I assumed the quantities, they could change based on those you are given, so the results might be different, but the procedure is quite the same.
Best regards.
Answer:
Metalloids are metallic-looking brittle solids that are either semiconductors or exist in semiconducting forms, and have amphoteric or weakly acidic oxides. Typical nonmetals have a dull, coloured or colourless appearance; are brittle when solid; are poor conductors of heat and electricity; and have acidic oxides.
Explanation:
Speed in km/hr = 15 x 18
------------
5
= 54 km/hr.
Hope this helps!
Answer:
Acid solution
Explanation:
In acid-base titrations carried out in school and college labs, many of the older generation, well-informed teachers told their students that the acid solution should be taken in the burette.
Answer:
A) Melting
Explanation:
The three changes of phase described in this problem are:
- Melting: melting occurs when a substance in solid state turns into liquid state. Since molecules in liquid state have more energy than molecules in solid state (because in liquids, molecules can slide past each other, while in solids they can't move, but only vibrate), thermal energy must be added in order to melt a substance
- Freezing: freezing occurs when a liquid substance turns into solid state (the opposite of melting). Since molecules in liquid state have more energy than molecules in solid state, thermal energy must be removed from the substance in order to cause freezing
- Condensation: condensation occurs when a gaseous substance turns into liquid state. Since molecules in gaseous state have more energy than molecules in liquid state, thermal energy must be removed from the substance in order to cause condensation
So the correct option is
A) melting
