Answer:
Distillation will generate the most cyclohexene.
Explanation:
Let us assume following attached reaction for the synthesis of cyclohexene from cyclohexanol which attains equilibrium after certain time.
As shown in figure the cyclohexanol upon treatment with phosphoric acid undergoes dehydration reaction (removal of water) and produces cyclohexene. On the other hand cyclohexene reacts with water (hydration reaction) and produces cyclohexanol.
Now, if this reaction is allowed in a single flask it will attain equilibrium and will not generate the cyclohexene in high quantity. On the other hand if we apply <em>Le Chatelier's principle</em> ( <u><em>removal of product moves the equilibrium in right direction</em></u>) and distillate cyclohexene (boiling the cyclohexene to convert it into vapors and then collect it after condensation) will move the reaction in forward direction and will allow us to generate cyclohexene in high amounts.
Answer:
saturated fats
Explanation:
bcoz it is solid at room temperature and does not have double bonds between carbons
Answer:
Q = mcT ...you can either substitute the molar heat capacity of water in the place of c or the specific heat capacity of water.
Explanation:
Answer:
In 1 mol of Pb₃(PO₄)₄ occupies 1001.48 grams
Explanation:
This compound is the lead (IV) phosphate.
Grams that occupy 1 mole, means the molar mass of the compound
Pb = 207.2 .3 = 621.6 g/m
P = 30.97 .4 = 123.88 g/m
O = (16 . 4) . 4 = 256 g/m
621.6 g/m + 123.88 g/m + 256 g/m = 1001.48 g/m
1.one substance must dissolve another : the solvent breaks the the solute causing it to dissociate into the solvent it can be both solids or gases that dissolve in the solute
2.the melting point will be higher than 100 degrees as the salt causes the solution to gain a higher melting point
3.either released or absorbed : energy is required to dissolve the solute but the solute may also release energy
4.the salt dissolved most quickly in the warm water : as there is more energy for the solute to dissolve
hope that helps