Which of the following is not an example of a mass movement?
to. a. Ground slides b) acid rain c. mud flow d. drop
Answer:
b) acid rain
Explanation:
Acid rain is not an example or a type of mass movement.
Mass movement or mass wasting is the movement of rocks, soils and other debris downslope under the influence of gravity.
Water, slope and gravity are triggers of mass movement.
- Acid rain is a not a form of mass movement
- It occurs with some certain gases mixes rain water to produce an acidic precipitation.
- When the water falls to the each surface, it causes problems to the ecosystem and can also corrode building materials.
The heat lost by copper(ii) sulfate is equal to heat absorbed by water since the total energy in the system remains constant according to the law of conservation of energy.
<h3>How can the number of moles be determined?</h3>
The number of moles of a substance is determined using the formula below:
- Number of moles = mass/molar mass
Assuming the mass of copper(ii) sulfate used is <em>Mc</em>, number of moles of copper(ii) sulfate used is:
- Moles of copper(ii) sulfate = <em>Mc</em>/159.60 moles
The heat absorbed by water is calculated using the formula below:
- Quantity of Heat, H = mass × specific heat capacity × temperature change
mass of water <em>=</em><em> </em> 10 g
Let temperature change be <em>Tc</em>
Heat<em> </em>absorbed<em> </em>by water = 10 × 4.186 × Tc = 41
86Tc
The change in internal energy, ΔU of copper(ii) sulfate, is given as:
where:
Q = heat absorbed by water
W = work done by or on the system
The enthalpy of the reaction is given as:
- ΔH= energy released or absorbed/moles of copper (ii) sulfate
Therefore, according to the law of conservation of energy, the total energy in the system remains constant.
Learn more about internal energy change at: brainly.com/question/14126477
Answer:
The heat produced by this reaction is 2887J
Explanation:
The reaction of HCl with NaOH occurs as follows:
HCl + NaOH → H2O + NaCl + ΔH
<em>Where ΔH is released heat due the reaction</em>
<em />
The equation of a coffee cup calorimeter is:
Q = C*m*ΔT
<em>Where Q is heat produced, </em>
<em>C is specific heat of the solution (4.18J/g°C), </em>
<em>m is mass of the solution (50mL + 50mL = 100mL = 100g -Because density is 1g/mL) </em>
<em>and ΔT is change in temperature (28.9°C - 22.0°C = 6.9°C)</em>
<em />
Replacing:
Q = 4.184J/g°C*100g*6.9°C
Q = 2887J
The heat produced by this reaction is 2887J
<em />
If I goes through 2 gallons per minutes then it would be the half the rate. that the salt will go so if 50 gallons of water goes 25 oz of salts will go with it