<span>This is due to the fact that the air pressure in that certain section of Earth’s atmosphere decreased. As density of gas particles decreases as air pressure decreases. Therefore, density of gas particles and air pressure have a direct relationship. An increase in air pressure would then effect to an increase in gas particles. </span>
Answer: beta, gamma, alpha
Explanation: Beta is weakest gamma is middle alpha is strongest
Answer:
118.22 atm
Explanation:
2SO₂(g) + O₂(g) ⇌ 2SO₃(g)
KP = 0.13 =
Where p(SO₃) is the partial pressure of SO₃, p(SO₂) is the partial pressure of SO₂ and p(O₂) is the partial pressure of O₂.
- With 2.00 mol SO₂ and 2.00 mol O₂ if there was a 100% yield of SO₃, then 2 moles of SO₃ would be produced and 1.00 mol of O₂ would remain.
- With a 71.0% yield, there are only 2*0.71 = 1.42 mol SO₃, the moles of SO₂ that didn't react would be 2 - 1.42 = 0.58; and the moles of O₂ that didn't react would be 2 - 1.42/2 = 1.29.
The total number of moles is 1.42 + 0.58 + 1.29 = 3.29. With that value we can calculate the molar fraction (X) of each component:
The partial pressure of each gas is equal to the total pressure (PT) multiplied by the molar fraction of each component.
Rewriting KP and solving for PT:
Answer:
a) 320: two significant figures.
b) 2,366: four significant figures.
c) 73.0: three significant figures.
d. 532.5: four significant figures.
Explanation:
Hello there!
In this case, according to the given information, it turns out possible for us to write each number by knowing we move the decimal places to the right as much as the exponent is, and also, we count every figure, even zeros, because they are to the right of the first nonzero digit:
a) 320: two significant figures because the rightmost zero is not preceded o followed by a decimal place.
b) 2,366: four significant figures.
c) 73.0: three significant figures, because the zero is followed by the decimal place.
d. 532.5: four significant figures.
Regards!
To solve this we use the equation,
M1V1 = M2V2
where M1 is the concentration
of the stock solution, V1 is the volume of the stock solution, M2 is the
concentration of the new solution and V2 is its volume.
M1V1 = M2V2
1% x V1 = 0.25% x 10 mL
V1 =2.5 mL
Therefore, you will need to have 2.5 mL of the 1% HCl solution and 7.5 mL of distilled water. In mixing the two liquids, you should remember that the order of mixing would be acid to water. So, you use a 10 mL volumetric flask . Put small amount of distilled water and add the 2.5 mL of HCl solution. Lastly, dilute with distilled water up to the 10 mL mark.