Adhesive.
Adhesive is the force of attraction between molecules of different kind. Liquid flows upward the wick because the adhesive force between the wick and the liquid is higher than cohesive forces in the liquid.
When the adhesive force between the wick and the liquid is high we have capillarity taking place. This cause the liquid to move up the wick.
The percentage error in his experimental value is -51.97%.
<h3>What is percentage error?</h3>
This is the ratio of the error to the actual measurement, expressed in percentage.
To calculate the percentage error of the student, we use the formula below.
Formula:
- Error(%) = (calculated value-accepted value)100/(accepted............. Equation 1
From the question,
Given:
- Calculated value = 4.15 g/cm
- accepted value = 8.64 g/cm
Substitute these values into equation 1
- Error(%) = (4.15-8.64)100/8.64
- Error(%) = -4.49(100)/8.64
- Error(%) = -449/8.64
- Error(%) = -51.97 %
Hence, The percentage error in his experimental value is -51.97%.
Learn more percentage error here: brainly.com/question/5493941
Answer:
4. 7.59276
Explanation:
Add up the x components:
Aₓ + Bₓ + Cₓ = 5 − 1.6 + 2.4 = 5.8
Add up the y components:
Aᵧ + Bᵧ + Cᵧ = -2.4 + 3.3 + 4 = 4.9
Use Pythagorean theorem to find the magnitude:
√(x² + y²)
√(5.8² + 4.9²)
√57.65
7.59276
Answer:
The answer ro this question is fear of failure
Answer:
a. 2143 turns/m
b. 111.5 m
Explanation:
a. The minimum number of turns per unit length (N/L) can be found using the following equation:
Hence, the minimum number of turns per unit length is 2143 turns/m.
b. The total length of wire is the following:
Since each turn has length 2πr of wire, the total length is:
Therefore, the total length of wire required is 111.5 m.
I hope it helps you!