Hiii
3. describe the physical characters that can be observed: phenotype
6. a specific characteristic of an organism: trait
7. a section of DNA that provides instructions for specific traits: genes
8. allele expressed in the phenotype even if only one copy is present in the genotype: dominant
hope this helped :)
The boiling point of plain water is less than the boiling point of both salt and sugar water.
<h3>What is boiling point?</h3>
Boiling point can be defined as the point when the pressure exerted by the surroundings upon a liquid is equal to the pressure exerted by the vapour of the liquid.
The boiling point of plain water is 100°C which increases upon addition of solute substances such as salt and sugar.
But salts are usually made up of ionic bonds while sugar are made up of covalent bonds. This means that more energy would be required to boil salt solution due to its ionic bonds.
Therefore, the boiling point of salt water is highest following sugar water before plain water which is the lowest.
Learn more boiling point here:
brainly.com/question/14008526
#SPJ1
Answer:
1.17 mol
Explanation:
Step 1: Write the balanced equation
2 Al + 6 HCl → 2 AlCl₃ + 3 H₂
Step 2: Calculate the moles corresponding to 85.0 g of HCl
The molar mass of HCl is 36.46 g/mol.
85.0 g × 1 mol/36.46 g = 2.33 mol
Step 3: Calculate the number of moles of H₂ produced from 2.33 moles of HCl
The molar ratio of HCl to H₂ is 6:3.
2.33 mol HCl × 3 mol H₂/6 mol H₂ = 1.17 mol H₂
The correct answer is industrial smog. This type of smog exists in coal power plants which creates smoke and sulfur dioxide which may mix with fog creating a thick blanket of haze. Sulfur dioxide is one primary component of an industrial smog.
