Answer:
D.
40 x 6.4 = 256
256/128=2 so 2 gallons.
Step-by-step explanation:
Answer:
.
Step-by-step explanation:
Given information:
Period = 24 hr
Maximum = 16 at t=16 hr.
Minimum = 10 at t=4 hr.
The general sin function is
.... (1)
where, |A| is altitude, is period, C is phase shift and D is midline.
Period is 24 hr.
Altitude is
The function is minimum at t=4 and maximum at t=16,phase shift is
Substitute these values in equation (1).
Therefore, the required function is .
Answer:
a. 720
b. 0.3
Step-by-step explanation:
a.
Three balls are selected at random without replacement.
First ball can be selected in 10 ways
Second ball can be selected in 9 ways
Third ball can be selected in 8 ways
Thus, there are 10×9×8 =720 different ways of selecting three balls.
b.
There are three cases that satisfy this condition
- first ball picked is 5, the others are not
- first ball is not 5, second is 5, third is not
- first and second ball is not five, third ball is 5
Each probabilities are:
Thus, one of the balls selected is the number 5 is then
Answer:
$9,979,032,100 or $9.979 billion
Step-by-step explanation:
The approximate weight of a $100 bill is 1 gram.
All of the calculations bellow assume that the volume of the bills would not be an issue and only concerns weight.
1 pound is equivalent to approximately 453.59237 grams.
The weight in grams that the Big Falcon Rocket can carry is:
Since each bill weighs 1 gram, the number of bills it could carry, rounded to nearest whole bill is 99,790,321. The total amount it could carry is:
Answer:
First, plot points A & B on a graph.
Collinear just means 3 or more points in a straight line (because just 2 points are always collinear, since a straight line can always be drawn through two points.
The instructions don't state a specific area in which points C & D have to be in, so you can put them anywhere, as long as they are collinear with each other, but not any other points,
- i.e. putting three units up and two units left of points A & B
So let's make up some points for C & D that are on a straight line.
- Remember, this line does <em>not</em> have to be horizontal! As long as it's a straight line, any direction will do.
Here are some points that you can choose from:
- C(-1, 1); D(-1, -1)
- C(4, 5); D(4, -5)
- C(3, 4); D(3, 5)
- Anything that doesn't fall on x=2 or y=±3.
For "F" just pick a set of coordinates off to the side and label it
You can even use half values if you want:
- (0.5, 3.2)
- (1.2, -4.1)
- (-9.1, -0.2)
As long as your plotted points meet the criteria:
- C & D are <em>Collinear</em>
- A, B, C, D, & F must not land on the same straight line.