Answer:
Point a
Explanation:
The potential energy of an object is given by :
P = mgh
m is mass, g is acceleration due to gravity, h is height above ground level.
Potential energy is directly proportional to the position of an object.
In the attached figure, the maximum height is shown at point (a). It means it will have maximum potential energy at a as compared to b,c and d.
Step-#1:
Ignore the wire on the right.
Find the strength and direction of the magnetic field at P,
caused by the wire on the left, 0.04m away, carrying 5.0A
of current upward.
Write it down.
Step #2:
Now, ignore the wire on the left.
Find the strength and direction of the magnetic field at P,
caused by the wire on the right, 0.04m away, carrying 8.0A
of current downward.
Write it down.
Step #3:
Take the two sets of magnitude and direction that you wrote down
and ADD them.
The total magnetic field at P is the SUM of (the field due to the left wire)
PLUS (the field due to the right wire).
So just calculate them separately, then addum up.
Answer:
Since binary is only 1 and 0, you can use a flashlight to display something similar to Morse code (see explanation below)
Explanation:
In binary, 1 means "on" and 0 means "off". A way you can use visible light is through turning on and off a flashlight. If the flashlight is turned on, it would represent a 1. If the flashlight is turned off, it would represent a 0. To make the message easier and more accurately understood for the receiver make sure to flash the lights in a consistent pattern (ex. each flash lasts no longer than half a second, one second between each digit, etc.)
For example, let's say you're trying to send the message "11001"
on on off off on
0 1 2 3 4 5 <em>Numbers represent seconds</em>
As you can see above the message starts at 0 seconds. Between 0 and 1 seconds the flashlight is turned on once. Between 1 and 2 seconds the flashlight is turned on again, Between 2 and 3 seconds as well as 3 and 4 seconds the flashlight is not turned on at all. And finally between 4 and 5 seconds the flashlight is turned on.
Answer:
Explanation:
Assuming the pith balls as point charges, we can calculate the repulsive force between them, using Coulomb's law:
We observe that the magnitude of the electric force is directly proportional to the product of the magnitude of both signed charges(
) and inversely proportional to the square of the distance(d) that separates them.
Replacing the given values, where k is the Coulomb constant:
Putting gas in your car is one way you are using non-renewable resources.
You could Reduce, Recycle and Re-use items. You could manage what you do with you're water. Reducing and reusing products cuts down on manufacturing pollution, just as the use of recycled instead of virgin materials prevents pollution in industrial processes. You could add food coloring to your toilet tank. You could also do this: use sprinkler heads that sprinkle mist out instead of droplets of water. to avoid losing water to evaporation.
