Catalytic Converter is the correct answer. Toxic gases are produced in the combustion reaction of an engine, and when this gas adheres to the converter, it’s chemically transmuted into something that’s harmless.
Answer:
(D) Na₂SO₄•10H₂O (M = 286).
Explanation:
- The depression in freezing point of water by adding a solute is determined using the relation:
<em>ΔTf = i.Kf.m,</em>
Where, ΔTf is the depression in freezing point of water.
i is van't Hoff factor.
Kf is the molal depression constant.
m is the molality of the solute.
- Since, Kf and m is constant for all the mentioned salts. So, the depression in freezing point depends strongly on the van't Hoff factor (i).
- van't Hoff factor is the ratio between the actual concentration of particles produced when the substance is dissolved and the concentration of a substance as calculated from its mass.
(A) CuSO₄•5H₂O:
CuSO₄ is dissociated to Cu⁺² and SO₄²⁻.
So, i = dissociated ions/no. of particles = 2/1 = 2.
B) NiSO₄•6H₂O:
NiSO₄ is dissociated to Ni⁺² and SO₄²⁻.
So, i = dissociated ions/no. of particles = 2/1 = 2.
(C) MgSO₄•7H₂O:
MgSO₄ is dissociated to Mg⁺² and SO₄²⁻.
So, i = dissociated ions/no. of particles = 2/1 = 2.
(D) Na₂SO₄•10H₂O:
Na₂SO₄ is dissociated to 2 Na⁺ and SO₄²⁻.
So, i = dissociated ions/no. of particles = 3/1 = 3.
∴ The salt with the high (i) value is Na₂SO₄•10H₂O.
So, the highest ΔTf resulted by adding Na₂SO₄•10H₂O salt.
Answer:
it's got to do something with milk I guess it's the sugary substance found in milk and it's a compound
Answer:
a :Chemical b : compound
Explanation:
a : it had to be a chemical change because it says "There is no change in
the appearance of the solid, but the reactivity of the material changes.
b : well it would be a compound because it would have to be to make a reaction
I believe the answer is 8