Aluminum is an element. If there's nothing else in the foil
besides aluminum, then the foil is entirely an element.
Answer:
aqueous acid is used as a reagent.
Explanation:
Addition of Grignard reagent in aldehyde and followed by the acidification give rise to the primary or secondary alcohol. when the formaldehyde is used than the primary alcohol is formed otherwise secondary alcohol is formed.
in this reaction we also use the aqueous acid for the acidification as a reagent. We add aqueous acid when ethanol is present. This is because ethanol is get converted in the presence of aqueous acid into the chloroethane.
Answer: 27.09 ppm and 0.003 %.
First, <u>for air pollutants, ppm refers to parts of steam or gas per million parts of contaminated air, which can be expressed as cm³ / m³. </u>Therefore, we must find the volume of CO that represents 35 mg of this gas at a temperature of -30 ° C and a pressure of 0.92 atm.
Note: we consider 35 mg since this is the acceptable hourly average concentration of CO per cubic meter m³ of contaminated air established in the "National Ambient Air Quality Objectives". The volume of these 35 mg of gas will change according to the atmospheric conditions in which they are.
So, according to the <em>law of ideal gases,</em>
PV = nRT
where P, V, n and T are the pressure, volume, moles and temperature of the gas in question while R is the constant gas (0.082057 atm L / mol K)
The moles of CO will be,
n = 35 mg x x
→ n = 0.00125 mol
We clear V from the equation and substitute P = 0.92 atm and
T = -30 ° C + 273.15 K = 243.15 K
V =
→ V = 0.0271 L
As 1000 cm³ = 1 L then,
V = 0.0271 L x = 27.09 cm³
<u>Then the acceptable concentration </u><u>c</u><u> of CO in ppm is,</u>
c = 27 cm³ / m³ = 27 ppm
<u>To express this concentration in percent by volume </u>we must consider that 1 000 000 cm³ = 1 m³ to convert 27.09 cm³ in m³ and multiply the result by 100%:
c = 27.09 x x 100%
c = 0.003 %
So, <u>the acceptable concentration of CO if the temperature is -30 °C and pressure is 0.92 atm in ppm and as a percent by volume is </u>27.09 ppm and 0.003 %.
C) Fluorine is the most reactive among halogens
There are 5 significant figures in the following number. All of the numbers essentially are significant.