Is the divine injunction found in Genesis 1:28, in which God, after having created the world and all in it, ascribes to humankind the tasks of filling, subduing, and ruling over the earth.
Hello!
Since the two weights are <em>off</em> the table, the block will move towards letter F.
I hope this helps :))
The phases of the moon are the changing appearances of the moon, as seen from Earth. Which phase happens immediately after a third quarter moon are the following
Explanation:
- After the full moon (maximum illumination), the light continually decreases. So the waning gibbous phase occurs next. Following the third quarter is the waning crescent, which wanes until the light is completely gone -- a new moon.
waning gibbous phase
- The waning gibbous phase occurs between the full moon and third quarter phases. The last quarter moon (or a half moon) is when half of the lit portion of the Moon is visible after the waning gibbous phase.
Time takes by the moon to go through all the phases
about 29.5 days
- It takes 27 days, 7 hours, and 43 minutes for our Moon to complete one full orbit around Earth. This is called the sidereal month, and is measured by our Moon's position relative to distant “fixed” stars. However, it takes our Moon about 29.5 days to complete one cycle of phases (from new Moon to new Moon).
- At 3rd quarter, the moon rises at midnight and sets at noon. Then we see only a crescent. At new, the moon rises at sunrise and sets at sunset, and we don't see any of the illuminated side!
The power that the light is able to utilize out of the supply is only 0.089 of the given.
Power utilized = (0.089)(22 W)
= 1.958 W
= 1.958 J/s
The energy required in this item is the product of the power utilized and the time. That is,
Energy = (1.958 J/s)(1 s) = 1.958 J
Thus, the light energy that the bulb is able to produce is approximately 1.958 J.
Answer:
The size will increase.
Explanation:
When you bend a plastic ruler, it's size will increase because it is elastic and will exhibit elastic deformation. When it is been bent, it will continue to stretch until it get to a point where it will not be able to regain it formal shape, it size wound of increase. Therefore when the ruler get to elastic limit and you have bend it to the point it cannot regain it's formal shape back, it will remain bent and if further force is apply on it,it will break.
