Answer:
C. 2 mph
Explanation:
speed equals total distance covered in total time of of travel
since,
total distance = 4 miles
time taken = 2 hrs
speed = 4m / 2hrs =2mph
We can solve the problem by using Ohm's law, which states that an Ohmic conductor the following relationship holds:
where
is the potential difference applied to the resistor
I is the current flowing through it
R is the resistance
In our problem, I=4.00 A and
, so the potential difference is
Given :
The ball of a ballpoint pen is 0.5 mm in diameter and has an ASTM grain size of 12.
To Find :
How many grains are there in the ball?
Solution :
Volume of ball of the ballpoint is :
Now, grain size of 12 has about 520000 grains/mm³.
Therefore, number of grains are :
Answer:
1070 Hz
Explanation:
First, I should point out there might be a typo in the question or the question has inconsistent values. If the tube is 40 cm long, standing waves cannot be produced at 42.5 cm and 58.5 cm lengths. I assume the length is more than the value in the question then. Under this assumption, we proceed as below:
The insert in the tube creates a closed pipe with one end open and the other closed. For a closed pipe, the difference between successive resonances is a half wavelength .
Hence, we have
.
The speed of a wave is the product of its wavelength and its frequency.
Remember, that while sped is constant, acceleration is not. Acceleration is when velicity changes. So the graph which shows the slop <span>of a velocity vs time describes acceleration.
</span>If we have the straight line on the graph it means that the slope is always the same whereas the <span>non-linear graphs has a variable slope that changes depending on your point in the graph.
</span>To conclude - if your graph is not a straight line it has variable acc at many points.<span>
</span>