Answer:
The answer is below
Explanation:
The separation technique is used for separating immiscible liquids.
When separating, the stopper has to be removed when draining the lower layer so as to prevent a vacuum. If vacuum is allowed, the draining rate will reduce and stop.
The liquid should be mixed by shaking the funnel and then opening the stopcock so as the vent out gases.
When near interface between the layers, you should set your eye level so that you do not drain up to the second layer.
After completely draining the first layer, the second layer should be collected in a new flask.
After mixing the solutions in a separatory funnel, the stopper should be removed and the liquid should be mixed thoroughly and the layers allowed to separate. When you get close to the interface between the layers, get eye level with the funnel and slow the draining until the first layer is collected. Switch to a new flask to collect the second layer.
You can pick up any garbage that you see. Talk to people and hear what their ideas are for helping the environmental.
Answer:
The criteria listed in order of importance are;
1) To be inflated in the event of a collision in order to protect the occupants of the front of the vehicle
2) To be able to withstand the load of the breaking force of the occupants in the front seat of the vehicle during a collision
3) To be relatively tough so as to resist being torn on impact with a sharp object
The constraints listed in order of importance are;
1) How is the model design able to sense a collision that requires the airbag to be inflated
2) The uncertainty of the load the airbag will withstand upon collision
3) The possible hazard that could be caused by the gas used to inflate the airbag
4) The usage/interaction tendency between the vehicle occupant and the airbag system
Explanation:
In order to produce an effective design, it is important to be able to foresee the possible deficiencies of an idea so as to be able to mitigate the problems before an actual incident happens.
Answer:
8.3
Explanation:
pH is the measure of the H+ or H30 (they r the same thing) ions in a solution. it is equal to -log[H+]. [H+]= Molar concentration of H+ ions.
Answer:
The correct answer is vertebrate enzyme hydrolyze alpha-1,4 glycosidic linkage but not glucose in the beta configuration.
Explanation:
The amylase that is present inside human body is called salivary alpha amylase,an enzyme that digest the alpha-1,4-glycosidic linkages of starch but does not act on those glycosidic linkages which are present in beta configuration.
Cellulose contain beta-1,4-glycosidic linkages.That"s why it is not digested by the alpha amylase enzyme present inside the human body basically present in the saliva.
