Answer is "C".
<em><u>Explanation
</u></em>
Single replacement reaction is a type of reaction which one reactant reacts with another and makes a product by replacing one element by another.
Mg (Magnesium) reacts with Al₂O₃ (Aluminium oxide) and produces MgO (Magnesium oxide) and Al (Aluminium) as products. Here Al is replaced by Mg. Reaction is
Mg + Al₂O₃ → MgO + Al
To balance the reaction equation, both left and right hand sides should have same number of atoms in each element.
Here,
<em>Left Hand Side has </em> <em>Right Hand Side has</em>
Mg = 1 atom Mg = 1 atom
Al = 2 atom Al = 1 atom
O = 3 atom O = 1 atom
First step : balance the O atoms in both sides. To do that "3" should be added before MgO.
Second step : After balancing O atoms, there will be 3 Mg atoms in right hand side. Hence to balance Mg atoms again "3" should be added before Mg in left hand side
Third step : as the final step balance the Al atoms by adding "2" before Al in the right hand side.
Then final balanced equation should be
3Mg + Al₂O₃ → 3MgO + 2Al
Answer: 72.41% and 26.90% respectively.
Explanation:
At 60°C, you can dissolve 46.4g of acetanilide in 100mL of ethanol. If you lower the temperature, at 0°C, you can dissolve just 12.8g, which means (46.4g-12.8g)=33.6g of acetanilide must have precipitated from the solution.
We can calculate recovery as:
So the answer to the first question is 72.41%.
For the second part just use the same formula, the mass of the precipitate is the final mass minus the initial mass, (171mg-125mg)=46mg.
So the answer to the second question is 26.90%.
Changes into new substances called product.
Answer:
The of a substrate will be "10 μM".
Explanation:
The given values are:
Reaction velocity,
As we know,
⇒
On putting the estimated values, we get
⇒
⇒
⇒
On subtracting "40" from both sides, we get
⇒
⇒
Answer:
Explanation:
Hello,
In this case, since silver is initially hot as it cools down, the heat it loses is gained by the liquid, which can be thermodynamically represented by:
That in terms of the heat capacities, masses and temperature changes turns out:
Since no phase change is happening. Thus, solving for the heat capacity of the liquid we obtain:
Best regards.