The correct answer is D) Dan's sister was correct because Dan's legs touched the car seats. That is an indicator of heat transfer by conduction.
Conduction only happens when a heated object touches a non-heated (or not as heated) object. Radiation did cause the car to become hot, but conduction caused Dan to get burned.
Hope this helps!! :D
<h2>Please mark me as brainliest please yaa!!!^_^</h2>
Answer:
Explanation:
Hello there!
In this case, it is possible to propose an energy balance in order to illustrate how the heat released by the reaction is absorbed by the water:
Thus, since the heat released by the reaction is -112 kJ (-112000 J), it is possible to define the hear absorbed by the water in terms of mass, specific heat and temperature change:
In such a way, it is possible to define the final temperature as shown below:
Best regards!
Answer:
Explanation:
Primary and secondary succession occur after both human and natural events that cause drastic change in the makeup of an area. Primary succession occurs in areas where there is no soil and secondary succession occurs in areas where there is soil.
In primary succession, newly exposed or newly formed rock is colonized by living things for the first time. In secondary succession, an area previously occupied by living things is disturbed—disrupted—then recolonized following the disturbance.
Hope this helped :)
-<em>Akito</em>
Answer:
Uses nuclear reactions to produce energy
Implodes a fuel pellet
Explanation:
Laser fusion is a method of initiating nuclear fusion reactions through heating, and compressing fuel pellets containing deuterium and tritium using high energy density laser beams. Lase fusion is also known as inertial confinement fusion and the energy produced by the process is known as Laser Inertial Fusion Energy, LIFE.
During the process of laser fusion, small pellets of deuterium-tritium (DT) isotopes mixture are fed into a blast chamber where they are compressed to high densities using a number of amplified laser beams in the chamber.
The high energy density of the beams as well as the heat produced due to compression, induces the thermonuclear explosion ignition resulting in the production of high energetic products such as charged particles, x-rays and neutrons. The energy produced is absorbed and stored as heat in a blanket that is then used in a steam thermal cycle to generate electrical power.
There are two methods of compression of the DT pellet: direct and indirect-drive laser fusions.
However, there are a number of limitations to energy production by this process. One limitation is that the process is extremely inefficient in energy energy production. Also, the heat produced by the flashtubes results innthe deformation of the laser glass.