Answer:
you can simply answer by derivative = 3.5x^2+25x+250-y=0 you can derivate this eqn 7x +25-1=0 7x=24 yo u can divide you get it
Answer:
Explanation:
Formula
W = I * E
Givens
W = 150
E = 120
I = ?
Solution
150 = I * 120 Divide by 120
150/120 = I
5/4 = I
I = 1.25
Note: This is an edited note. You have to assume that 120 is the RMS voltage in order to go any further. That means that the peak voltage is √2 times the size of 120. The current has the same note applied to it. If the voltage is its rms value, then the current must (assuming the properties of the bulb do not change)
On the other hand, if the voltage is the peak value at 120 then 1.25 will be correct.
However I would go with the other answerer's post and multiply both values by √2
Answer:
The boiling point temperature of this substance when its pressure is 60 psia is 480.275 R
Explanation:
Given the data in the question;
Using the Clapeyron equation
where 
is the change in enthalpy of saturated vapor to saturated liquid ( 250 Btu
T is the temperature ( 15 + 460 )R
m is the mass of water ( 0.5 Ibm )
is specific volume ( 1.5 ft³ )
we substitute
/ 
272.98 Ibf-ft²/R
Now,
where P₁ is the initial pressure ( 50 psia )
P₂ is the final pressure ( 60 psia )
T₁ is the initial temperature ( 15 + 460 )R
T₂ is the final temperature = ?
we substitute;
480.275 R
Therefore, boiling point temperature of this substance when its pressure is 60 psia is 480.275 R
Build a filter.
Dig water from the ground
Answer:
C: You must know force and distance to calculate both.
Explanation:
A force is said to have done work, when it has succeeded in causing displacement in an object from its starting point.
Power can be defined as the rate of doing work.
The work can be calculated using the following formula:
Work done = Force × Displacement
The power can be calculated using the following formula:
Power = Work \ Time
In order to calculate the work and power, the force and distance should be known. The force and distance will help in the calculating the work, which will in turn help in the calculation of the power of the object.
Hence, the answer is you must know force and distance to calculate both.
