Answer:
The response that are true are:
- linear function has a constant additive rate of change, while a nonlinear function does not.
Since in linear function the rate of change is always equal as for a linear function we get a equation of line such that the slope is same.
- On a graph, the function must be a straight line to be linear.
Liner means there is a straight line of the function.
( Also it need not be true that the independent variable increases by 1.
There may be change of some other quantity in independent variable )
Start by writing the system down, I will use to represent
Substitute the fact that into the first equation to get,
Simplify into a quadratic form (),
Now you can use Vieta's rule which states that any quadratic equation can be written in the following form,
which then must factor into
And the solutions will be .
Clearly for small coefficients like ours , this is very easy to figure out. To get 5 and 6 we simply say that .
This fits the definition as and .
So as mentioned, solutions will equal to but these are just x-values in the solution pairs of a form .
To get y-values we must substitute 3 for x in the original equation and then also 2 for x in the original equation. Luckily we already know that substituting either of the two numbers yields a zero.
So the solution pairs are and .
Hope this helps :)
check the picture below.
recall that in a square, all four sides are equal, therefore b = a.
so the perimeter is then 6√2 + 6√2 + 6√2 + 6√2, or 24√2.
Answer:
V = 4000 ft³
Step-by-step explanation:
if diameter is 20 then radius is half that, or 10
use formula:
V = 4/3(3)(10)³
V = 4(10)³
V = 4(1000)
V = 4000 ft³