Answer:
a
because the mechanical wave is when it goes over and over again
Answer:
When the voltage is at a maximum positive value, the the current is at a value that is maximum and positive
Explanation:
We know that the relation between the Voltage and the current is given using the Ohm's law, which states that the voltage (V) is directly proportional to the current (I)
Mathematically,
V ∝ I
Hence,
When the voltage is at a maximum positive value, the the current is at a value that is maximum and positive
<span>The total
energy stored is the sum of the energy stored in the capacitors. If the
capacitors are series connected
capacitors, then the charging current is the same for both capacitors. This
means that each capacitor stores the same energy and the stored energy is two
times the energy of any of the capacitors.</span>
Answer: To increase the rigidity of the system you could hold the ruler at its midpoint so that the part of the ruler that oscillates is half as long as in the original experiment.
Explanation:
When a rule is displaced from its vertical position, it oscillates back and forth because of the restoring force opposing the displacement. That is, when the rule is on the left there is a force to the right.
By holding a ruler with one hand and deforming it with the other a force is generated in the opposite direction which is known as the restoring force. The restoring force causes the ruler to move back toward its stable equilibrium position, where the net force on it is zero. The momentum gained causes the ruler to move to the right leading to opposite deformation. This moves the ruler again to the left. The whole process is repeated until dissipative forces reduce the motion causing the ruler to come to rest.
The relationship between restoring force and displacement was described by Hooke's law. This states that displacement or deformation is directly proportional to the deforming force applied.
F= -kx, where,
F= restoring force
x= displacement or deformation
k= constant related to the rigidity of the system.
Therefore, the larger the force constant, the greater the restoring force, and the stiffer the system.
4A. PE = MxGxH. (You can consider g as 9.8 / 10m/s as well)
509 J = 12x10xH
509 J = 120xH
H = 509/120
H = 4.24 m
Hope u got the answer....pls rate the answer if it is helpful for u....and I'm sorry I could not understand B part so I didn't do it.
Thank you