The properties which keep the water temperature from changing much are;
- water's high specific heat capacity
- the large mass of water
<h3>What is specific heat capacity?</h3>
The specific heat capacity is the property of a substance that shows how much its temperature changes when it is exposed to heat.
Thus, the properties which keep the water temperature from changing much are;
- water's high specific heat capacity
- the large mass of water
Missing parts:
A red-hot iron nail is immersed in a large bucket of water. Although the nail cools down sufficiently to be held bare-handed, the temperature of the water barely increases. Which properties keep the water temperature from changing much?
A.) water's high heat conductivity
B.) water's high specific heat capacity
C.) the iron nail's high heat conductivity
D.) the large mass of water
E.) the iron nail's high specific heat capacity
Learn more about heat capacity:brainly.com/question/12244241
#SPJ1
the answers is cacih2
wjdgagqjdhdgahahdhvddvvsvshsd
Copper (I) oxidation state is 1 Cu2So4
copper (II) oxidation state is +2 CuSo4
copper (i) also give up one electron so you need two of them to react with the sulfate ion (which has charge of -2)
and also all metallic ions have an multiple oxidation levels corresponding to the number of electrons they can exchange or loose
Hope this helps
Answer:
The traditional electrolyte for aluminium electrolysis is based on molten cryolite (Na3AlF6), acting as solvent for the raw material, alumina (Al2O3).Metals are found in ores combined with other elements. Electrolysis can be used to extract a more reactive metal from the ore.
Aluminum can and is used as both anodes and cathodes in electrochemical cells, but there are some peculiarities to using it as an anode in aqueous solutions. As you note, aluminum forms a passivating oxide layer quite readily, even by exposure to atmosphere. In an aqueous solution, if the potential is high enough, OH− and O2− are generated at the anode, which can then react with the aluminum to produce aluminum oxide. Al^3+ can also be generated directly. The electric field will draw the anions through the growing aluminum oxide layer towards the aluminum surface and the Al^3+ towards the solution, making the oxide layer grow both away from the electrode surface and into the surface of the electrode. In this way, coatings thicker than the normal passivation in air can be produced. However, aluminum oxide is a good electrical insulator, thus if a dense non-porous layer is grown, it will become impossible to pass current through it and growth will stop, leaving a relatively thin oxide layer (this is how the dielectric layers in electrolytic capacitors are made). This is the normal behaviour in aqueous solutions at near-neutral pH (5–7).
However, if a thick aluminum oxide layer is desired (e.g. to produce coatings on aluminum parts for dying or durability), maintaining porosity is necessary to avoid completely blocking access to the surface. One technique that is commonly used is using a low pH solution, which tends to redissolve some of the oxide and neutralize some of the formed OH−, leaving pores in the oxide layer through which the ions can travel and continue to react. These pores also give a good structure to retain dyes or lubricants, but generally need to be sealed after to protect against corrosion.
Yes, it's changing the appearance of the metal caused by rain, salt, or acid
