Wouldn't it be neat if an electron falling closer to the nucleus ... emitting a
photon ... actually gave out more energy than it needed to climb to its original
energy level by absorbing a photon ! If there were some miraculous substance
that could do that, we'd have it made.
All we'd need is a pile of it in our basement, with a bright light bulb over the pile,
connected to a tiny hand-crank generator.
Whenever we wanted some energy, like for cooking or heating the house, we'd
switch the light bulb on, point it towards the pile, and give the little generator a
little shove. It wouldn't take much to git 'er going.
The atoms in the pile would absorb some photons, raising their electrons to higher
energy levels. Then the electrons would fall back down to lower energy levels,
releasing more energy than they needed to climb up. We could take that energy,
use some of it to keep the light bulb shining on the pile, and use the extra to heat
the house or run the dishwasher.
The energy an electron absorbs when it climbs to a higher energy level (forming
the atom's absorption spectrum) is precisely identical to the energy it emits when
it falls back to its original level (creating the atom's emission spectrum).
Energy that wasn't either there in the atom to begin with or else pumped
into it from somewhere can't be created there.
You get what you pay for, or, as my grandfather used to say, "For nothing
you get nothing."
Between the top of the first and the top of the second loop, the coaster has lost potential energy = mgh, where h = 22.2 - 15 = 7.2m
This energy would have converted to Kinetic. Write out an equation and the masses will cancel out. Does that hint help you to find the solution? If not, I will give you another hint.
Answer:
D and A
Explanation:
Hint The basic difference between them is that a bar magnet is a permanent magnet whereas an electromagnet is a temporary magnet. An electromagnet is formed when an electric current is passed through wires wound around soft metalcore. An electromagnet loses its magnetism once the current flow is stopped.
Answer: Technician B is right.
Explanation:
Evacuation process is used in refrigeration systems to remove moisture, air and non-profit condensable gases in order to achieve maximum function of the system.
vacuum pump is used to draw the sealed AC system into a vacuum. Evacuation of a refrigerant system also helps to maintain pressure, this is so as pulling a vacuum on the system is simply removing matter (mostly air and nitrogen) from inside the system so that the pressure inside drops below atmospheric pressure.
