When
Nucleophile (Alkoxide) reacts with Alkyl Halide (
Substrate), Ether (
product) is formed with the elimination of
Leaving group (Iodide in this case).
This is
SN² a nucleophilic substitution reaction which takes place in primary alkyl halides. Reaction is given as,
Question: Baking a Cake Without Flour.
Hypothesis: I think that when I remove the flour from the standard cake recipe, I'll end up with a flat but tasty cake.
Procedure: I baked two cakes during my experiment. For my control, I baked a cake following a normal recipe. I used the Double Fudge Cake recipe on page 292 of the Betty Crocker Cookbook. For my experimental cake, I followed the same recipe but left out the flour. I first obtained a 2-quart mixing bowl.
Results: My control cake, which I cooked for 25 minutes, measured 4 cm high. Eight out of ten tasters that I picked at random from the class found it to be an acceptable dessert. After 25 minutes of baking, my experimental cake was 1.5 cm high and all ten tasters refused to eat it because it was burnt to a crisp.
What did I learn?/Conclusion: Since the experimental cake burned, my results did not support my hypothesis. I think that the cake burned because it had less mass, but cooked for the same amount of time. I propose that the baking time be shortened in subsequent trials.
-
I hope this helped :))
Answer:
Here's what I get.
Explanation:
(b) Wavenumber and wavelength
The wavenumber is the distance over which a cycle repeats, that is, it is the number of waves in a unit distance.
Thus, if λ = 3 µm,
(a) Wavenumber and frequency
Since
λ = c/f and 1/λ = f/c
the relation between wavenumber and frequency is
Thus, if f = 90 THz
(c) Units
(i) Frequency
The units are s⁻¹ or Hz.
(ii) Wavelength
The SI base unit is metres, but infrared wavelengths are usually measured in micrometres (roughly 2.5 µm to 20 µm).
(iii) Wavenumber
The SI base unit is m⁻¹, but infrared wavenumbers are usually measured in cm⁻¹ (roughly 4000 cm⁻¹ to 500 cm⁻¹).
Answer:
An element with 7 valence electrons will most likely be a halogen and gain an electron
Explanation:
Its a formula relating to specific heat capacity
Δθ refers to the change in temperature
Q refers to the energy neededto raise the temperature of an object by the change in temperature
m stands for the mass of tje object
c is the specific heat capacity which is the amount of energy needed to heat up an object per unit mass
