Answer:
The 1st and 4th options are correct
I.the oxidized form has a higher affinity for electrons
IV. the greater the tendency for the oxidized form to accept electrons
Explanation:
Half reaction can be described as the oxidation or reduction reaction in a redox reaction.it is In the redox rection there is a change in the oxidation states of Chemical species involved. the oxidized form in the redox has a higher affinity for electrons and the greater the tendency for the oxidized form to accept electrons.
Standard reduction potential which is also referred to as standard cell potential can be described as the potential difference that exist between cathode and anode of the cell. In the standard reduction potential most times the species will be reduced which is usually analysed in a reduction half reaction.
(Standard Hydrogen Electrode) is utilized when determining the Standard reduction or potentials of a chemical specie. this is because of Hydrogen having zero reduction and oxidation potentials, as a result of this a measured potential of any species is compared with that of Hydrogen, the difference helps to know the potential reduction of that particular specie.
The cost of gasoline for the trip would cost $57.28 because you first divide 320 by 20 which gives you 16 than after that you do 16 multiplied by 3.58 which gives you $57.28 as your final product
Answer:
Number of molecules = 1.8267×10^20
Explanation:
From the question, we can deuced that the gases behave ideally, the we can make use of the ideal gas equation, which is expressed below;
PV = nRT
where
P =pressure
V =volume
n = the number of moles
R is the gas constant equal to 0.0821 L·atm/mol·K
T is the absolute temperature
Given:
P = 6.75 atm;
T = 290.0 k,
; V = 1.07 cm³ = 0.001 L
( 6.75 atm)(0.00107 L) = n(0.0821 L·atm/mol·K)(290K)
n = 3.0335167*10^-4 moles
But there are 6.022×10²³ molecules in 1 mole,
Number of molecules = 1.8267×10^20
Ionization energy increases from left to right in the row and from bottom to top in a column. Also as we get closer to the nucleus it would be harder to take electrons out. B (atomic #5) has 2 layers of electron 2 and 3 atom in each layer. P has 15 so it would be 2,8 and 5 respectively. Ca is 20 so 2,8,8,2 and Zn is 30 and it would be 2,18,8,2.
For energy between second and third ionization we are looking at taking out the 3rd electron. B already has 3 electron in the first layer so its easy to take them all. P has 5 in the last layer so again easy. But when we look at Ca and Zn after the 2nd electron (in the last layer) we should change the layer go one layer inside. So this needs more energy. To pick between Zn and Ca (they are in the same row) I mentioned earlier that in one row as we go to the right ionization energy increases so the answer is Zn.
It is going to be 11% of 100
11/100*100=11gram